AutomaticHigh Precise High Efficiency Pick and Place Machine
8, 10, or 16 heads of multifunctioal pick and place machine
Automatic highspeed chip pick and place machine
Automatic glue dispenser machine
Eton's customer in 35 countries around the world
1. We have been helping customers to build a lot of new factories around the world.
2. Training more than 500 experts and technician for customers.
3. Became the most reliable Chinese partner for you.
For SMT factory setup,we can do for you:
1. We provide fulL SMT solution for you
2. We provide core technology with our equipments
3. We provide the most professional tech service
4. We have wealthy experience on SMT factory setup
5. We can solve any question about SMT
Accurately place, manager, and track components with Smart Feeders
Apply to different kinds of SMD components: LED chip, capacitors, resistors, IC,RGB, shaped components,etc.
Applicable Products: It's suitable for power driver, electric boards,LED screen, bulb, down light, panel, strip, lamp, street light, ceiling light and etc.
RT-1 Technical Parameter
PCB Length Width
Group picking and separate placing\separate picking and separate placing
No. of Camera
2 sets of imported camera
Vision for the flight identification + MARK correction
Mounting repeat Precision
<40mm(component max height 20mm)
LED chip,capacitors,resistors,IC,RGB,shaped components etc.
X,Y,Z Axies Driving
Magnetic linear motor+servo motor
No. of nozzles
Machine maintenance skills
Check the part name and process note every week. Check the buffer action of the nozzle clamp. If the action is not smooth, apply a thin layer of lubricant. If the clamp is loose, tighten it. Move the lens to clean the dust and residue on the lens. Check the x-axis lead screw for debris or residue and clean if necessary. Check the grease for hardening and residue adhesion on the x-axis guide rail. Check the y-axis lead screw for debris or residue and clean if necessary. Check the grease for hardening and residue adhesion on the y-axis guide rail. Check whether there is debris or residue in the screw of W-axis. Clean the air interface if necessary, check whether the Y-shaped seal ring and O-ring are aged, and replace them if necessary.
The monthly inspection of this part should be carried out according to the type of suction nozzle and nozzle changing station. Move the LED lamp of the lens to check whether the brightness of each LED is enough. If not, replace the whole LED part. Check the O-ring used for each nozzle shaft, and replace it in time if it is found to be aging. X-axis lead screw to wipe dust and residue, apply a thin layer of grease by hand, X-axis guide rail to remove dust and residue, Y-axis lead screw to wipe dust and residue, Y-axis guide rail to remove dust and residue, apply a thin layer of grease to z-axis rack and gear by hand, and apply a thin layer of lubricant on rack transmission parts if necessary. Check the wear and tightness of R-axis drive belt, and replace the belt or adjust its tightness if necessary. Wipe off the dust and residue of the W-axis lead screw, and apply a thin layer of grease by hand to check whether the solenoid valve can work normally. Check the wear and tightness of the conveyor belt. If necessary, replace the belt or speed up its tightness.