0.6 M Conveyor
Do not install the machine in dusty, oil mist, conductive dust, corrosive gas, flammable gas, humidity, shock vibration, high temperature and outdoor environment use.
Working group: This is mainly done by professional installation personnel.
Please check whether the power supply meets the requirements after the power is switched on, whether the power switch is normal or not.
After power on, check the emergency stop switch and whether the protection device is normal.
The movement part is mainly responsible for the constant speed motor and cylinder, each part of the position detection by the stroke switch or eye induction.
Do not make the cylinder running too fast, and make it smooth and smooth.
The position of each sensor needs to be well adjusted.
The position of each inductor can be input from the movement controller and the indicator lamp is detected.
The output status is detected from the output point indicator of the motion controller.
Its running program has been controlled by internal programming, and the customer can not change it.
Steel frame structure, rail length
Width adjustment range
7MM flat belt conveyor
Adjustable from 0.5 to 9 m/min
Set of stepper motor
Industrial control panel
Single(left→right or right→left)
One section of control, two Sensors
Set of electric control box
1. Ensure that there is no foreign matter in the transportation part, belt, belt wheel and guide rail, and ensure smooth and smooth transportation.
2. Regularly oil the transmission part and the rack or width adjusting screw rod, and the oil shall be executed in the stopped state.In case of power failure, please immediately turn off the main power switch of the equipment.
According to customer requirements
1, Modular design
2, Iron square tube framework, powder coating on surface
3, Ergonmic design table for parts place and arm rest
4, standard SMEMA
5, Variable speed control
6, Width adjustbale